Electronics Standard Products: Component Handling
- Automatic Dispensing 1 & 2K Materials
- Board Handling
- Carriers
- Conveyors, FiFo/ LiFo, Turn & Flip Units
- Cutting
- Line loading / Unloading
- Storage
- Chairs
- Cleaning PCB's
- Cleaning: Stencil, Screen & Frames
- Component Handling
- Dispensing heads 1 & 2K components
- Fume Extraction
- Furniture
- Inspection: X-ray and AOI
- Ionic Contamination Tester
- Manual Dispensing 1 & 2K Materials
- Marking & Traceability
- Pick & Place
- Process Aids Cleaning
- Process Optimalisation
- Repair PCB (SMD & THT)
- Selective Coating
- Soldering
- Wave
- Vapor Phase
- Solder Paste
- Process Aids Solderbath and Selective Tips
- Solder Wire
- Selective
- Reflow
- Soldering and Repair Flux
- Solderpaste Printing
- Used Equipment
- Vacuum Dispensing 1 & 2K Materials
County Component Counter
- It counts in both directions (right or left).
- It is equipped with a divider from 1 to 19 and a TOTALIZER mode counting or PRESET mode, with an alarm that starts when the desired component number has been reached.
TP/SC4 Pneumatic Cutting Forming machine for Loose Radial Components
- The model with three cylinders is suggested to operate power transistors, when it is necessary to spread out and form the outer leads and sprad the central one.
- The simplicity of its operation and the large assortment of forms make this model one of the most reliable machines available on the market.
TP6/PR-B Cutting, Bending and Forming machine for Axial Components (Taped)
The machine handles components with lead diameter from 1 to 1,4mm.
The high quality and reliability of the TP6/PR-B ensure the best operation for a very long time.
Maintenance is mainly performed by cleaning the discs.
Options:
- CS10 loose component feeder
- Motor driven
- TNS ejection of the waste tape.
TP6/R Cutting machine for Taped Radial Components
The high quality and reliability of this machine ensure the best operation for a very long time.
Maintenance is mainly performed by cleaning the discs.
Options:
- Motor driven
- TNS ejection of the waste tape
County/S Motorized SMT Component Counter
- Totalizer: components are counted from a zero reference, tape feed is motorized and the counter automatically stops at the tape end, to prevent loss of the total.
- Preset mode: the desired component number is keyed on the keyboard and the counter automatically stops when it reaches the corresponding component.
- All functions are easy to operate by the interactive messages on the display, while system status is monitored by means of LEDS near the control keys.
TP/R-PR Pneumatic Cutting Forming machine for Taped Radial Components
- The tape is manually fed into the die and the correct position of the component for a proper forming, is given by a front pin.
- The die assembly “SMS” is always equipped with a wire holder to keeps leads firm in position during the machine operation.
- The replacement of the SMS, to change the form, just takes few minutes.
TP/TC4 Cutting machine for Loose Radial Components
- Two belts hold the leads and feed them through the rotory blades, that cut them, without any bur and damage to the components
- The cutting height can be adjusted by turning an allen screw
TP/LN500 Pneumatic Cutting machine for Loose Radial Components
- This model can handle any kind of components regardless of the diameter, pitch and form.
- The standard grid patern accomodates most types of components. Special grid plates can be provided upon request.
TP6 Cutting and Bending machine for Axial Components (Taped)
Options:
- CS10 loose component feeder
- Motor driven
- TNS ejection of the waste tape